Hello ​@redaz,

Thank you for reaching out, and welcome to the Docusign Community! We are absolutely delighted to have you here and can't wait to share our knowledge with you.

You can customize your Docusign connect settings to include other events, and the trigger will process them. The trigger is a single-select list, and if you are looking for ‘recipient-completed’ and not ‘signed,’ do not switch the trigger to ‘recipient-completed’ unless that is the only event you want in your flow.

If you want both ‘recipient-completed,’ leave the trigger as is and manually add the ‘recipient-completed’ event to the Connect configuration. The trigger won’t reflect this new event, so you just need to remember that you’ve added it.

I hope you find this helpful. If you believe this response effectively addresses your question, please click “Select as Best” to help other users with similar questions, locate it more easily. Should you require any additional assistance, feel free to reach out. Thank you!

Best regards,

Jenny | Docusign Community Moderator

"Select as Best" below if you find the answer a valid solution to your issue.

Hello ​@redaz,

I hope you are doing well. I want to confirm if you were able to solve your issue by utilizing the suggested solution or if the information provided was useful. If so, please mark it as the "Best Answer " by clicking “Select as Best” to make it easier for other users to find. Otherwise, let me know and I will gladly help you address the situation as soon as possible.

Best regards,

Jenny | Docusign Community Moderator

"Select as Best" below if you find the answer a valid solution to your issue.